Wiring a Bathroom
Even a relatively large bathroom tends to be damp. Light fixtures must be watertight, ventilation must be effective, and the receptacles should be ground fault circuit interrupters.
The lights and fan must be on a different circuit from the receptacle(s). Some codes require that bathrooms have their own circuits; others permit bathrooms to share circuits with receptacles or lights in other rooms. In some locales all bathroom wiring -- including the lights -- must be GFCI-protected.
The Vent Fan
To satisfy codes and for your comfort, a bathroom needs a fan that effectively pulls moist air out and sends it outside. Some local codes require that the fan always comes on when the light is on; others allow you to put the fan on its own switch.
Usually there is a vent/light fixture in the middle of the ceiling, which may be controlled by one or two switches. Some fixtures also include a heating unit or a nightlight. A bathroom heater -- whether it is a separate unit or a part of a fan/light -- may use so much electricity that it requires its own circuit.
In addition to a light or fan/light in the middle of the ceiling, plan to position lights over the sink, where they can shine on a person standing at the mirror. A strip of lights above the mirror is a common arrangement, but most people find that two lights, one on each side of the mirror, illuminate a face more clearly. A mirror light's switch may be by the entry door or near the sink.
A tub or shower does not need to be brightly lit, but people shouldn't have to shower in the dark. Install a recessed canister light with a waterproof lens made for shower areas.
Install at least one 20-amp GFCI receptacle within a foot or so of the sink. Position the receptacle so a cord does not have to drape over the sink when someone is using a blow-dryer.
- Electrical Safety: Steps for Developing Safe Habits
- Electrical Project Planning & Prep
- Your Electrical System
- Basic Electrical Wiring Techniques
- Electrical Repair, Problem Solving & Maintenance
- Switches & Receptacles: How to Replace or Upgrade a Switch or Receptacle
- Lights & Fans: Mounting and Wiring Light Fixtures & Fans
- Cable & Boxes: How to Install Electrical Cable & Boxes
- New Fixtures: How to Install a New Electrical Fixture
- Fans & Heaters: How to Install a Fan or Home Heater
- Household Voice, Data & Security: How to Install Your System
- Outdoor Wiring: How to Install & Plan Outdoor Wiring Projects
- Appliances & Circuits: How to Install Appliances & New Circuits