Making a Dimensional Floor Plan
To determine if the area is square, use the 3-4-5 triangle method: Snap a chalkline on the floor or tack a mason's line at the midpoints of each pair of opposite walls. From the intersection measure out on one line a distance of 3 feet. Tape the line at that point and measure and tape a distance of 4 feet on the other line. Now measure the distance diagonally between the tapes. If it's 5 feet exactly, the floor is square. Adjust the lines, if necessary, until they are perpendicular. Now measure from the lines to the out-of-square walls at each end and post this measurement on your drawing.
Wavy walls may also affect your drawing. Check them with a 4-foot level and represent the condition on your drawing as accurately as possible.
Check the floor to determine if it is level and flat. If the floor is not level, it won't affect the final look unless you are also tiling a wall. But floors must be reasonably flat (within 1/8 inch in 10 feet) to keep the tile from cracking.Wavy Walls
Wavy walls can result in edge tiles with uneven cuts. Use a 4-foot level to check the surface of the wall near the floor. If the problem is not severe, the cuts may not be noticeable.
When drawing a layout plan, try the following solutions. Minor variations in a wall surface may actually "disappear" if hidden under a baseboard.
More severe depressions in a wall can be leveled with a skim coat of thinset prior to tiling the floor. Feather the edges of the skim coat to blend in with the level surface. Skim-coating, however, requires proper preparation of the wall so the mortar will stick. You will also have to tile the wall, paint it, or cover it with another material.Laying out different configurations
In a rectangular or square room, pencil in reference lines at the midpoints of the walls and draw in tiles on both axes. If you have the tiles, lay them out on the floor to make your drawing more accurate. Adjust the placement of the lines so the pattern ends in even borders if possible.
When laying out an L-shape room, position the lines so they carry from one room to the other. Adjust them so the layout results in even borders if necessary.
To establish lines for a diagonal layout, first pencil in lines at the midpoints of the room. Then on each axis mark an equal distance from the intersection. Extend these points until the extensions intersect. Draw diagonal lines from the intersections through the midpoint.Out-of-square floors
An out-of-square floor surface will require tapered tiles on at least one edge. Place the tiles on your layout plan to make the tapered tiles less noticeable. Modify the grout width, hide cut edges under toe-kicks, or arrange your layout so the tapered edges fall behind furniture. Try a diagonal layout or a larger, irregular tile to hide the tapered edges. In extreme cases you can shim out the wall and rebuild it.Pro Tip: Plan full tiles in doorways
When you are preparing a dimensional layout plan, draw the tiles in so a full tile will fall with its edge in the center of a doorway. If you can't set a full tile in the doorway because your plan already incorporates wide border tiles, you may be able to minimize the effect of a cut tile with a threshold in the doorway. If the tile continues into an adjoining room, center a tile at the doorway, if possible, so an even portion falls in each room.
- Choosing the Right Flooring: Information & Picture Gallery
- Preparing a Room & Floor for New Flooring
- Installing Ceramic & Stone Tile: How To Install Tile
- Installing Wood Flooring: How To Install a Wood Floor
- Installing Laminate Flooring: How To Install a Laminate Floor
- Installing Resilient Floors: How To Install a Resilient Floor
- Installing Carpeting: How To Install Carpet
- Installing & Staining Cement Overlays: How to Install Cement Floors
- Installing & Finishing Baseboards: How To Install Baseboard
- Paint & Epoxy: How to Apply a Paint or Epoxy Floor Coating
- Floor Repair: How to Repair & Maintain Floors